PCM Southern, LLC - Wall Systems

ADEKA Walls

ADEKA Walls ADEKA is a pre-formed VM ZINC® shingle

product that allows rapid installation. The tiles are installed with

a 2" overlap. Polystyrene bonded to the underside provides

increased sound insulation from rain and hail. ADEKA can also

be used as a roof element.

ADEKA elements are installed quickly and easily, starting from the

bottom and working up, using three screws in pre-drilled rimmed

holes. The bottom row is held in place with a locking key fitted to

adjacent ADEKA elements.

With ADEKA, designers can create a striking tile effect using the

natural grey color of zinc without having to resort to artificially colored

metals. It is available in both surface aspects, QUARTZ ZINC® and

ANTHRA ZINC®.

Flatlock Panels

Umicore’s Flat Lock Panels offer a simple yet elegant cladding solution that provides a longitudinal flat seam. The system uses a simple fold interlock on all four sides and can be installed in either horizontal or vertical orientations. This solution is suitable for all buildings up to 100’ (30m). The pre-formed panels are easy to install and are available in both QUARTZ ZINC® and ANTHRA ZINC®.

Interlocking Wall Panel

Interlocking Panels are a Tongue-and-groove system with concealed fasteners. This panel system can be oriented either horizontally or vertically. Up to a length of 10 feet it can be through-fastened, above that the Umicore sliding clip must be utilized. The maximum width of this system is 12 inches on center, it is installed top down. Umicore recommends using this system for buildings with a height of up to 100 feet. When the ends of the panel are exposed, it is recommended to fold the ends closed. IL panels offer an interesting design feature. Since the reveal can be designed between 1/4" minimum and 3/4" maximum. The designer has the opportunity to alter reveals which gives the impression of different size panels or different size lines over the wall. You can specify IL-Panels in QUARTZ ZINC® and in ANTHRA ZINC®.

Corrugated Panels

VM Sine Wave ZINC - Corrugated Panels

VM Sine Wave ZINC is the corrugated panels by Umicore. Corrugated panels are one of the oldest panel systems in construction. When made from VM ZINC®, corrugated panels take on a completely new look. Sine Wave Panels are a very economical wall product due to their simple installation.

The standard module of our Sine Wave Corrugated is 7/8" x 2-7/8". Needless to say that other sizes and also perforations are available.

You can specify Sine Wave Panels in QUARTZ ZINC® and in ANTHRA ZINC®.

Standing Seam for Walls

For facades, we recommend single lock standing seams primarily for design intent concerning shadow pattern and seam straightness. Double lock standing seams may be subject to waviness due to the inherent seaming process which may waiver along the seam length. For the same reason we recommend 0.8mm or 0.032" thick zinc.

Cladding walls in this system is a very traditional technique. The Single Lock (also known as Angle Lock) give the cladding a taut and regular look.